How to Use

Step 1:

Paint it on

Using a 4" paint-roller brush, apply 3 THICK COATS. Thicker is better.  Be generous - paint a base coat and wait 5 minutes or so between coats 2 and 3, all in one simple application process. The above photo shows 3 coats after drying for 20 minutes or so. It's turning clear... 

Step 2:

let it dry

Dry time depends upon the temperature, humidity, and available sunlight. For fastest dry time, dry in the sun.  It dries clear and leaves a slight texture depending on what type of roller-brush fabric you use (e.g. mohair, microfiber).

Step 3:

Play!

You're protected against rock chips, tar, road rubber, you name it..clear bra alone is not enough and doesn't save you clean-up time.

Step 4:

Peel it off

Peel in the shade at 55-70 degrees (not the sun). Your paint must be completely cool. Start with an edge on the perimeter of your protected area. Apply even tension and pull gently close to the paint.  If you applied 3 coats, it will peel easily.  


helpful hints

  • The thicker you apply Protect ‘n Peel, the better the protection and the easier it will be to peel off.
  • It is essential to apply 2-3 VERY THICK coats.
  • Apply a base coat, let dry for 5 minutes, then coat #2.  Repeat.
  • For fastest drying, let it dry in the sun or drive your car around.
  • Only peel in the shade when the paint is completely cool.
  • Test it on a small section of your hood.  When peeled, it should be like Saran Wrap or thicker.

 

 

Subscribe